Posted on by
Back to Lighting...

Are you sure you want to delete this post and all the replies?

Hello, Mr Deakins, I just discover this website while doing some research, and it look great, so first thank to take time to bring to light the question of person less experienced than you.

I work in the electrical department since I move into the US, and I discover recently that I can have 240v on a circuit by removing the neutral and remplace it buy a hot from an other circuit if there are not on the same phase.

so in the case where I cannot have access to stage pin connector or cam lock, if I'm using a M40, I should be able to plug it on two 120v, 20 amp circuit.

Does that will work without causing problems to the electrical ballast or any safety issues ? 

Thank for any information you can give me.

Back to Lighting...